Welcome to Gaia! :: View User's Journal | Gaia Journals

I bought a call from my son yesterday about easy methods to repair a broken door frame - evidently one of many kids had run into the door hard sufficient to interrupt the door frame and he wished to find out about door frame repair. We determined to take away the door stop first to make sure we didn't harm it. This is a small piece of wood connected to the frame, or typically part of it, that the door comes up against when closed. The door body had shims between it and the studding behind it and we were additionally careful to avoid wasting these shims for re-use. The subsequent step was to install the new door frame and re-set up the molding and door stop.<img class='alignleft' style='float:left;margin-right:10px;' src='http://s3-media2.fl.yelpcdn.com/bphoto/3WaL5Z0JVH0trds8a4IGSw/ls.jpg' width='254' />
<br/>
<br/>If you'll want to safe the door down earlier than repairs are made to the photoeyes, reconnect the storage door to the opener. Most garage doorways should not have guide locks when they are operated by an opener. Earlier <a href="http://www.limitlessgaragedoors.com/">garage door white plains</a> than we could fix the door frame, the old body should be eliminated on the aspect the place it was cut up. The next step was to remove the door frame on the latch aspect, and this proved somewhat harder.
<br/>
<br/>We didn't break the door frame during elimination, but if we had of it would not have mattered as we had already purchased one other one. The door stop was subsequent; we rigorously aligned the top end with the door cease on the top of the door body and then closed the door and lightly pressed the underside finish of the door stop towards the door. Holding the door cease firmly against the door the door was once more opened and the cease nailed onto the door body using ending nails. We found the door stop to be barely warped, but by nailing prime and backside we have been then in a position to bend the stop into the once more closed door in order that it followed the door all the best way down and nail the center area.
<br/>
<br/>We selected to use longer ending nails by the molding into the studding behind, including simply a few smaller ending nails into the new door frame where the molding was bowed out from the door body and drove one at an angle into the top piece of molding and Voila!, the fastened door frame is ready for paint. While this door body repair took the two of us about two hours; it may have been performed easily in lower than one. It may be a little difficult when doing house repairs for the primary time and not likely knowing how you can do the job - I hope this helps when (and if) it's good to repair a damaged door body.<img class='alignleft' style='float:left;margin-right:10px;' src='http://pop.h-cdn.co/assets/cm/15/06/54cfc6a3e0d66_-_duct_tape_frozen_out_0109.jpg' width='254' />