You'll be surprised to see just the best way to spray car paint really can be simple. That doesn't mean that you can simply grab a tin of paint and go at it. There are some basics you need to know. Both in the preparation and application.
Step A:
Prepare by gathering all of your things that you're going to need. Ensure your surrounding area is protected against any possible over spray.
Step B:
You may have to analyze the car for any rough spots. These will need to be sanded with 300 grit sand paper. Additionally, it lets the spray automobile paint to stick better. Ensure all of the dust soil and debris are taken off the vehicle once you have finished sanding. It's imperative that the car be totally clean.
Measure C:
This will make sure you get an overall even coat of your colored paint plus helps the paint to stick well. Be sure to apply light coats and allow for drying Alloy Wheel Repair Harold Hill in between when you spray the primer. How to spray on auto paint takes a little getting used to.
Step D:
Now you might be pretty well to the point at which you're about ready to spray on the shade. In any case, make a few practice strokes on an item before you start with the car. Once you are ready, start the passes with the paint without hesitation. If you hold the spray can or gun in one place, you will get uneven coverage and perhaps the paint will run. If this happens you have an important repair job on your had. You will most likely have directions as to how you can spray on car paint using the spray or gear cans.
Step E:
You may want to study this choice on the web, or check with someone which is comfortable with the way to spray on car paint
Step F:
You are down to the finishing touches once you might be totally satisfied with the colour. You may now need to apply several clear coatings. This can give the gloss and finished look to the auto in addition to protect the finish. It will be up to you personally although probably two layers will be satisfactory. Make absolutely certain it truly is dry in between coats.
Step G:
If you prefer once again, you have the option of wet sanding. Again, I would recommend you ask the advice of people which are familiar with how to paint a car. You need with these grits in this arrangement if you determine to follow this measure then. This will remove spots which will not be too light in the clear coat application.
Step H:
Now you'll want to using a rubbing compound in order to use a 2000 grit to remove any scratches to buff the surface.
Step I:
You should now buff the surface. To try this just use a moderate cut polish. Once this has been done by you, you should have a perfect glassy appearance to the finish.
Step J:
As a final touch, you may want to apply a few layers of wax.
