Thanks guys :3
If I show the tools, I will feel even worse for how simply made these are
cry Here you go;
1. Screwdriver. The head was filed down flatter. I use this to make a fleshy patterns in areas of deep green stuff.
2. Sponge from a blister pack. I press it into dampened putty to create a sort of.. Moldy look.
3. My collection of "normal" sculpting tools.
4. Thin metal pipe. Hollow. One end is flattened to an even tip. The other is slightly rounded inwards [to create a smaller indent]
I use it to make boils/ lumpy skin.
5. Burr set. I use these for most of the rotten patches you've seen on my models. REALLY simple, just push it in over and over.
6. Needle. Has.. A few uses. Such as reminding you to not fumble about in the toolbox.
7. Plastic rod, cut to a 45 degree angle, smoothed and lovely. I use this when I need to make a solderer affect.
8. Plastic rod, groove filed into the end. Kind of like a half tube, really. Has a few minor uses.
9. Remnants of a dart. The spike is helpful for many things.
:3 there'ya go
Reply
