Wh
at it looked like step by step:

The start I used duct tape, chicken wire, and tin foil to mold the ears.

once again, i used tin foil to mold the base mouth piece.

i covered the mask with tin foil and used a pen knife to cut out the eyes.

i had started experimenting with different protection things that would let the mask take a beating and wouldnt scratch the paint, this stuff is called Mod Podge, it is like a puzzle preserver, not the stuff to use i dont recommend it. The stuff i did find that worked pretty well was Rust-oleum specialty Grip and Guard crystal cleat rubber coating, you will need about a can and a half of this stuff it is some heavy duty s**t.

For this i used a metallic paint, called Sophisticated Finishes Steel metallic surfacer. it came from Home Depot.

I used Horse teeth for this, i used a dremel to carve them into the right shape and size this came from the bottom jaw of a skull i found while looking for the bottome teeth of a cow, out in the bone yard behind my house I then painted them with an enamel nail polish to make them white, and shiny, also for the mouth i used a material called Fast Steel to fill the gap under the teeth and make the ridges.

I used a pair of grey sweats for the rest, for the chest i used some extra material Ace Hardware had. on a side note that is my sister's room, since she went off to college i am using it for my classroom because this year i am being home schooled, because i screwed up so bad in private school.

I used the same material from the chest to make the tail.

me in the finished product
