Step A:
Prepare by assembling all your items that you're going to need. Ensure your surrounding area is protected against any potential finished spray. Any parts that don't need to be sprayed and that can be removed subsequently do so.
Step B:
You will have to examine the car carefully. It also lets the spray auto paint to stick better. Make sure all the dust dirt and debris are removed from the vehicle once you have finished sanding. It is imperative the car be perfectly clean.
Measure C:
This will make sure you get an overall even coating of your colored paint plus helps the paint to stick nicely. Be sure to apply light layers and allow for drying in between when you spray the primer. The way to spray auto paint takes a little getting used to.
Step D:
Now you're well to the point at which you might be around ready to spray on the color. Before you begin with the car in any case, make a few practice strokes on an object. Once you might be ready, begin the passes with the paint without reluctance. You'll get uneven coverage, if you hold the spray can or gun in one spot and potentially the paint will run. If this happens you've got an important repair job on your had. You'll most likely have directions as to how exactly to spray car paint using the spray or equipment cans.
Step E:
You may want to research this choice on the web, or check with someone that's familiar with how to spray car paint
Step F:
Once you're completely satisfied with the shade, you are down to the finishing touches. You will now need to apply several coats that are clear. This will give the finished and gloss look to the auto along with protect the finish. It'll be up to you although likely two layers will be sufficient. Make absolutely sure it truly is dry in between coats.
Step G:
If you Alloy Wheel Repair Hornchurch prefer once more, you've got the option of wet sanding. Again, I will suggest you request the advice of people that are comfortable with how to spray paint an automobile. If you decide to follow this step then you need to wet sand with these grits in this arrangement. This will remove spots that could be too heavy in the clear coat application.
Step H:
Step I:
You should now buff the surface. To do this just use a moderate cut polish.
Step J:
As a final touch, you may want to apply a couple of layers of wax.
