http://www.youtube.com/watch?v=TUA3lryix64
Try making reusable sanding blocks by yourself. Cut six blocks from any 3/4" plywood you have, for each sandpaper grit you regularly use. Be sure that the measurements are around two-and-a-half inches by four-and-three-quarters inches. Use some spray adhesive on your blocks and the cork tile. Stick a block on your cork, then make certain you cut the cork flush with a utility knife. Put adhesive on a sheet of sandpaper and apply it on each block of cork. Finally, trim the sandpaper and label each block.
You can make your crosscut guides using stair gauges. With a carpenter's square these can be clamped down to match up the stair jack. Then you should mark all of the notches. If you put them on the same tongue of your carpenter's square, the combination that you can make will be a great circular saw crosscut guide.
When you want to cut narrower sections of wood, never use your own fingers to guide them. Using a piece of wood as a guide is much safer. This will assure you keep your fingers.
Know what a wood's characteristics are prior to staining it when you're working on a project. Low quality wood is considered "paint grade" and isn't meant to be stained. Along the same lines, veneer is very different from particleboard because the former will not necessarily absorb stain properly; however, the latter typically absorbs too much stain. Choosing the right wood will ensure your woodworking project turns out its best.
You likely already know that you want to have a ruler on hands at all times, but it can be hard to keep it from falling out of your pocket. Try switching to a metal ruler, keeping it in a pocket with your telescoping magnet, the kind used to reach and pick up screws or nails. The magnet should keep your ruler in the pocket.
You can use a golf tee to help tighten up the hinges of an interior door. You need to remove both the door itself and the individual hinges from the total door frame. Then, locate each screw hole put a golf tee in each one, tapping gently. Cut the part of the tees that do not fit into the screw holes before putting the door back in its frame. The screw has something to bite on with the golf tee.
Once you have read the tips included here, start using them and begin improving your skills. Of course there is a lot to understand, but make sure you have an open mind to gather in as much information as you can. Be sure to stay optimistic, woodworking will require you to be dedicated and patient.
