You'll be surprised to see just how to spray car paint really can not be difficult. That doesn't mean that you can only grab a tin of paint and go at it. There are some basics you need to understand. Both in the preparation and application.
Step A:
Prepare by gathering all of your things that you're going to need. Ensure your surrounding area is protected against any potential through spray. For other places cover well with paper and masking tape.
Measure B:
You'll have to analyze the car carefully. These will need to be sanded with 300 grit sand paper. It also enables the spray car paint to stick better. Ensure all the dust dirt and debris are taken from the vehicle once you have finished sanding. It's critical that the automobile be perfectly clean.
Measure C:
This will make sure you get an overall even coating of your colored paint plus helps the paint to stick nicely. When you spray the primer, make sure you allow for drying in between and apply light layers. How to spray car paint takes a little getting used to.
Step D:
Now you might be pretty well Alloy Wheel Repair Enfield to the point at which you are around ready to spray the shade. In any case, make several practice strokes on an item before you start with the auto. Begin the passes with the paint without reluctance, after you happen to be ready. You'll end up getting uneven coverage if you hold the spray can or gun in one area and possibly the paint will run. Should this happen you've got an important repair job on your had. You will most probably have directions as to how to spray auto paint using the gear or spray cans.
Step E:
Check with someone that's familiar with just how to spray car paint, or you may want to study this alternative on the web
Step F:
Once you might be thoroughly satisfied with the shade, you're down to the finishing touches. You'll now want to apply several clear coats. This will give the finished and shine look to the car in addition to protect the finish. Likely two layers will be adequate but it's going to be up to you personally. Make absolutely sure it's dry in between coats.
Step G:
Once more, you've the alternative of wet sanding if you prefer. Again, I will suggest you request the advice of people which are familiar with how to paint an automobile. You need with the following grits in this sequence if you determine to follow this measure then. This will remove spots that'll not be overly light in the clear coat application.
Step H:
Now you may need to using a rubbing compound in order to use a 2000 grit to remove any scrapes to buff the surface.
Step I:
You should buff the surface. To try this just use a moderate cut polish.
Step J:

As a final touch, you may want to apply a number of coats of wax.