Welcome to Gaia! :: View User's Journal | Gaia Journals

When I built my barn to house our Jeep workshop, I was not sure what kind of garage doors I wanted. At first We considered the standard expense roll up garage door. I possibly could have gotten these included in my steel developing kit. Price because of these garage doors was greater than I wanted to pay for my own barn, however. Click Here To Find Out...



I never found any that I appreciated, although i looked around for some utilised garage doors. When I built my house a few years back again I found a really nice set of wood garage doors that had a little rot at the bottom. I was able to make replacement parts for your doors out of redwood making use of my table saw along with a little creativity.

Nevertheless, for my barn, all the rollup and overhead doors that I found limited the overhead room too much. A primary reason I chose the mid-foot ( arch ) steel building design as to eliminate rafters so I did not want garage doors getting in the way of my hard earned headspace.

In my father's shop, we have always to make sure we close the doors just before jacking anything up extremely high because it will strike the garage doors. I did not want to duplicate that problem in my store.

I finally chose fabricating my own steel garage doors. Since I had lots of space outside the barn, I selected a garage door layout that allows the entrance doors to swing offered to the outside. To reduce the stress on the hinges, other and support frames garage door parts, My partner and i covered each every single garage door opening two separate garage doors. Each and every 10 by 15 garage door opening provides two 10 through 5 garage doors. A number of garage doors total for the two garage door openings.

I started by fabricating a new frame for each garage door out of one inch rectangular tubing. The body was a 10 simply by 5 rectangle sized to fit just in the garage door opening. My spouse and i faced the framework with light gage corrugated steel sheeting. Your sheeting makes a good match for the inspired finish on the remaining barn.

The garage door frame was welded together using but joints each and every corner and a straight brace going through the bottom of each joint side up to the opposite corner. The completed garage doors are flexible adequate to withstand being found I the plenty and wind strong enough to deliver security for the building.

I welded a lock hasp towards the joining sides from the garage doors so that they tend to be locked to each other pertaining to security. A simple padlock is all that is required to seal them up.

I think I spent about $200 on materials for your four garage doors. These kinds of cover two 15 by ten opportunities. They are easy to enter and exit so I don't need a power opener that I would've felt was required if I had chosen a roll up as well as overhead garage door. I was not able to uncover even a single utilised door for that price in my search. searching for Trever Nykilchuk


Overall I am very happy together with my barn style doors. They keep the rain and vermin away and my equipment in at night. They allow quick and easy vehicle access and most importantly do not take on up any on the inside headspace. And with no monitors or motors, these kind of garage doors have been totally maintenance free.


For images of these garage doors and much more barn raising pictures, discover mikestrawbridge.com/garage-doors.shtml

Mike Strawbridge is the owner of Hay Solutions Performance improvement consulting. To learn more about how you can improve your life, business or perhaps your Jeep, see world wide web.mikestrawbridge.com