Materials needed:
Lays "Stax"
Glue Stick, Paste etc.
Razor.
Pods, duh! make sure you use a pod that is nice and strait you don't want to use any VL pods because they have a slope to them like mine does :[
1: After your materials are all gathered, your first step is to clean your pods. Just wipe them down with a clean rap you don't want any dust and dirt to get mixed up with your glue.
2: Next, grab your Lays. Your going to need to a location to cut a strait line down the paper. Pick a location like the nutrition table etc. avoid cutting thru the front of the can. After your cut has been made you'll notice the cover is stuck to the can by a layer of glue on one side carefully peel it off try hard not to damage the cover.
3:When you have your cover removed from the can, set it aside. I used a glue stick. You don't have to, I just don't recommend using Elmers school white glue since it looks like the paper would absorb the glue. Paste is good too. Apply the glue to the area of the pod which will receive the cover.
4: Apply the cover, by gently pressing the cover over the glued area of the pod. avoid using colored paste and glue sticks. Clean/wipe the excess glue and let it sit and dry. Your done.
I Like BBQ ;]
See what I mean? Use good strait tube pods, it will give you a much better end result.
