You may be surprised to find only the best way to spray on car paint actually can be simple. That does not mean that you go at it and can just grab a tin of paint. There are some fundamentals you should understand. Both in the preparation and application.
Step A:
Prepare by assembling all your things that you're going to need. Be sure your surrounding area is protected against any potential finished spray. For other regions cover nicely with paper and masking tape.
Step B:
You may need to analyze the car carefully for any rough spots. This will smooth out the rough spots. Additionally, it allows the aerosol automobile paint to stick better. Once you've finished sanding, make certain all of the dust dirt and debris are taken off the vehicle. It's critical that the automobile be perfectly clean.
Measure C:
This will make sure that you get an overall even layer of your coloured paint plus helps the paint to adhere nicely. Be sure to apply light layers and allow for drying in between when you spray the primer. How exactly to spray car paint requires a little getting used to.
Step D:
Now you are pretty well to the point at which you happen to be around ready to spray the color. Before you start with the automobile in any case, make a couple of practice strokes on an item. Once you Alloy Wheel Repair Billericay are ready, begin the passes with the paint without hesitation. If you hold the spray can or gun in one spot, you will end up getting uneven coverage and possibly the paint will run. If this happens you've got a major repair job on your had. You will most probably have directions as to the best way to spray on auto paint using the equipment or spray cans.
Step E:
You may want to research this option on the internet, or check with someone that's comfortable with the way to spray on auto paint
Step F:
You are down to the finishing touches once you might be fully satisfied with the color. You may now want to apply several coatings that are clear. This can give the shine and finished look to the auto along with protect the finish. It will be up to you although likely two coatings will be adequate. Make absolutely certain it truly is dry in between coats.
Step G:
Once again, you have the alternative of wet sanding if you favor. Again, I will suggest you request the guidance of people that are familiar with the way to paint an automobile. You need to wet sand with the following grits in this sequence if you determine to follow this measure then. Use 800, 1000, 1200, 1500 and the ultimately the 2000. This will remove spots that may be overly heavy in the clear coat application.
Step H:
Now you will want to using a rubbing compound so you could use a 2000 grit to remove any scratches to buff the surface.
Step I:
You should now buff the surface. To try this simply use a medium cut polish. Once this has been done by you, you should have a perfect glassy look to the finish.
Step J:
As a final touch, you may want to apply a couple of layers of wax.
